Dear consumer:
Since the basic maintenance of the electrical panel increases its lifespan and optimal use, please pay due attention to the items listed in this instruction.
- Check the serial number of the board with other available documents.
- The board should be installed levelly and with sufficient strength in its place.
- As some connections may have come loose during shipping, make sure the internal connections are tight.
- The external connections of the panel (input and output cables) must also be secure and strong, check this as well.
- Before energizing the board, carefully inspect the interior again to ensure that foreign objects do not enter near the bus bars and other energized parts.
- Before turning on the panel, clean all the equipment from dust, etc.
- Do not open the screws of the body or the plates of the equipment and avoid using it for other purposes.
- It is not correct to directly connect any cable to the busbar and avoid this.
- The input and output cables must be secured by the clamps in the panel to prevent tension on the equipment contacts and their damage.
- If you need to change or replace the fuse, be sure to use the standard and approved type.
- Do not use long and non-standard screws to connect the cables to the outputs.
- If any of the output fuses are damaged due to short circuit or high current, be sure to completely clean the damaged fuse switch from the circuit and around it because its presence will again cause current leakage to the body and short circuit.
- If you notice a current leakage or abnormal sound when connecting the main automatic switch, try to fix the problem first, then connect the switch.
- Never remove the protection fuses of the street lighting line from the circuit.
- To prevent dust from entering the board, make sure there are filters in the board’s vents.
- The main automatic switch needs service after 3 to 5 TRIPs under rated short-circuit current, so be sure to write down the times of disconnection and connection due to short-circuit in the panel ID.
- Protection relays must be set by experts.
- It is very dangerous to make changes or … while connecting the main key. (even the seemingly simple act of changing the lamp inside the panel) because there is a possibility of an object or tool falling on the BUS BARS, so avoid this.
- After finishing the work, make sure that the panel door is closed.
- The inside of the panel must be dusted once every 6 months.
- For longer durability, grease the lock and hinge of the body of the panel every year, as well as stain the damaged areas.
Making changes in the warranty period must be done with the coordination of this company.
